Small patio side table – Everything you need for this job is a few carpentry tools plywood, stain or paint of your choice water sealant and hardware. Pick the five 2-by-4 boards and construct a square table. Add 3-meter long sections with the short sides on the floor parallel to each other three meters apart. Place two of the 2 feet, 9 inches long stretches in between them form a square. Fasten frame together by driving two 2 1/2-inch screws through both ends of the long distances in shorter ones.
Place remain 2 feet, 9-inch long 2-by-4 on the short edge of the center of the frame. Position it so that it runs parallel to the 3-foot sections of the square. Attach this section to the frame by running two 2 1/2-inch screws through the sides of small patio side table of the frame at each end. This section serves as a center support beam.
12 Photos Gallery of: DIY Small Patio Side Table Design
Place the 3-foot square section of plywood over the frame and set it. Drive 1 1/2-inch screws through the plywood every 6 inches all the way around the edge of the frame including the center beam. Turn the completed section of the top of the small patio side table.